We are away until the 31st of March, orders will be shipped once we re-open. Thank you.

FlatRacer BMW Monolever (85-96) DIN 12v auxiliary power socket kit

FlatRacer BMW Monolever (85-96) DIN 12v auxiliary power socket kit

FlatRacer BMW Monolever (85-96) DIN 12v auxiliary power socket kit

A very useful DIN 12v auxiliary power socket kit designed and produced by us to fit all the BMW Airhead Boxer Monolever (single rear shock) models made between 1985-1996.

Our kit includes: 

  • Stainless steel bracket, an improved replica of the often rusted and/or damaged original bracket
  • M6 x 16mm stainless steel flange button head bolt + washers and nyloc nut
  • Alloy bodied DIN female plug with a spring loaded lid (weatherproof plug available at no extra cost)
  • Weatherproof socket wiring rubber boot
  • Inline Continental  fuse holder (and a supplied 8amp fuse) 
  • Up-rated 33 amp/3.0mm2  thin-wall wires (red positive and brown negative) with M6 eyelet terminals for the battery
  • Plastic zip ties (4) to secure the wiring to the frame/battery tray if required

We've produced this kit with up-rated 33amp electrical wires (originals were rated at circa 16amp), easily capable of handling up to 400W draw for short periods if required (you will need to change the fuse to 30 amp).

Very practical and useful auxiliary power 12v DIN socket, allowing you to quickly connect (with the correct DIN plug/adaptor) a battery tender or charger, charge a GPS unit, a mobile, tablet, power pack or even a heated vest!

It is usually fitted to the rear sub-frame LH (left) side, on the gusset plate next to the seat lock mechanism (M6 hole), from inside the sub-frame.

Replaces the original BMW DIN socket: 61132300473 


Not recommend for power jumping to start the engine. Please use the correct power jump cables (ideally rated at over 100amp) as the starter motor can draw quite bit of power and will very likely overheat or burn the wires under continuous use.

Earn 0 reward points
£0.00 £49.99


Out Of Stock
Add To Wishlist