FlatRacer BMW Airhead Boxer steering & top nuts 36mm spanner tool 31-4-850

FlatRacer BMW Airhead Boxer steering & top nuts 36mm spanner tool


FlatRacer BMW Airhead Boxer steering & top nuts 36mm spanner tool 31-4-850


Designed and developed by us to enable secure and easy tightening and undoing of all the BMW Airhead Boxer 36mm steering centre top nuts and the 36mm fork top bolts typically fitted to all BMW /6 & /7 Series (73-84)

Our heavy duty 36mm spanner tool is designed to be to provide the maximum contact area to these thin section nuts, something most spanners and sockets cannot do due to their chamfered edges. Our spanner provides a safe and optimised access to all the BMW 36mm nuts . 

The spanner measures circa 180mm in total length thus enabling it to be fitted in the original tool roll. Provision to fit a 1/2" drive breaker bar or torque wrench is provided, along with a small semi-circular cut out to enable it to be hanged centered on a tool wall/board.

This tool is made of heavy duty 6mm flat thick steel, developed with a flank drive so it does not damage the nuts' edges as force is applied to the centre section of the hex sides, not the corners.

IMPORTANT: Care should be exercised when handling as this is an heavy tool. Personal protection equipment is recommended when handling it (ie: gloves and steel toe cap shoes).


Part replaces original BMW tool 31-4-850 (36/27mm spanner)


Similar spanner tools available for other sizes including the later post 1985 (Monolever) 41mm fork top nuts, the BMW /5 fork bottom nuts (30mm) and the steering bearing castellated nut adjuster. Please see our other listings.

Earn 0 reward points
£0.00 £22.49
QTY:
Out Of Stock
Add To Wishlist