BMW Airhead Boxer transmission output flange bolts torque adaptor

BMW Airhead Boxer transmission output flange bolts torque adaptor


BMW Airhead Boxer transmission output flange bolts torque adaptor

Special tool, designed and developed by us, to enable tightening the bolts securing all the BMW Airhead Boxer models (69-96) driveshaft to the gearbox output flange to the correct torque, using a torque wrench.

Carefully produced, keeping a very accurate geometry and preserving the crucial dimensions of the original BMW tool 00.2.560, with a 44mm ctc, in order to accurately use a good quality, calibrated 3/8 torque wrench to the specified torque figure for your bike model (see list below).

Designed to work specifically with the original BMW 12 point stretch bolts, reference 26111242297. These should always be replaced by new original bolts from factory or OEM spec. The new BMW original ones come with a thread lock compound, ready to use. If the compound is not present (usually a pink coat on the threads), use Loctite blue thread lock. Do not use spring or wave washers on the new stretch type flanged bolts (13mm long)  as these are not designed to accept it.

Made of heavy duty laser cut 8mm thick steel, offering sturdiness and a long working life.

Torque figures, using the torque adaptor with a torque wrench positioned exactly at 90 degree angle to the adaptor:


-  BMW /5 & /6            - 14,5mm long bolts            18-19 Lb/ft                    24.26Nm  (superseded by the later type stretch bolts, see below)

- BMW /7 & R45/65    - 13.0mm long bolts            28-31 Lb/ft                   38-42Nm

- BMW Monolever      - 13.0mm long bolts            23-29 Lb/ft                  32-40Nm

- BMW R100 GS          - 13.0mm long bolts            26-33Lb/ft                   35-45Nm

- All other models       - 13.0mm long bolts            28-31 Lb/ft                   38-42Nm


IMPORTANT: Fasten the bolts in increments, in a criss-cross pattern to evenly distribute the torque and ensuring the flanges are perfectly parallel and no distortion occurs.

Very useful and handy tool to keep in your tool roll for when dismantling the transmission flanges for repair, maintenance or simply the replacement of the rubber gaiter.



Earn 0 reward points
£0.00 £14.99
QTY:
Out Of Stock
Add To Wishlist