We are away until the 29th of July, orders will be shipped once we re-open. Thank you.

BMW Airhead Boxer 16mm push rod tube punch drift tool - 11-1-650

BMW Airhead Boxer 16mm push rod tube punch drift tool - 11-1-650


BMW Airhead Boxer 16mm push rod tube punch drift tool - 11-1-650


Punch drift tool designed to quickly and easily remove the push rod tubes out of the cylinders on the pre-September 1975 models

Made of hardened and phosphatised steel for wear and corrosion resistance, ensuring a long working life.

A proper tool, manufactured to withstand serious workshop use, not to be confused with inferior tools, which often deform and mush.

Will fit all 16mm (OD) push rod tubes, commonly fitted to the BMW /5, /6 and R90S produced up to September 1975. If in doubt, please measure your pushrod tubes Outside Diameter (OD) as often these engines have been modified or replaced.

Similar punch drift tool available for the later models (18mm OD).Please check our other listings.


ADVICE:

When removing the pushrods or installing these in place, it is advisable to gently heat the alloy cylinders first, either in a oven (if you have access to it) or with a heat gun. Care should be exercised as excess heat can distort the cylinders.

When re-fitting the pushrod tubes, these should be ideally placed on a fridge freezer for a few hours so the metal contracts, aiding its installation into place.

Earn 0 reward points
£0.00 £14.99
QTY:
Out Of Stock
Add To Wishlist